RCU Forums - View Single Post - Drilling wheel hubs out?
Thread
:
Drilling wheel hubs out?
View Single Post
10-02-2013, 09:22 AM
#
17
GoNavy
My Feedback: (
15
)
Join Date: Jan 2002
Location: Rib Lake, WI
Posts: 557
Likes: 0
Received 0 Likes on 0 Posts
I realize this thread is very old, but the advice was spot on. I used the prop reamer and got 1/4 inch.
I had used a 6.5mm drill bit, that is .2559, but the hole was still so tight you could not push the axle in.
Thanks to all.
Reply
Like
GoNavy
View Public Profile
Send a private message to GoNavy
Find More Posts by GoNavy
View iTrader Profile