The weather was nice today, so I slipped out the door at work for a quick couple flights. The engine wasn't running quite right, but it still had plenty of power for vertical accelleration. It would hover at about 1/4 to 1/3 throttle, and it felt very stable. Loops were very tight, and if it was slowed down it would flip from upright to inverted or back with just a blip of the throttle. Rolls seemed a little slow, but I had it slowed down most of the time. I think climbing spins will work once I figure the amount of throws needed to keep it from flipping over. I think it is going to be a good airplane for close in 3D work. I hope to have some pictures soon. Tom