RCU Forums - View Single Post - DX9 mix programming
View Single Post
Old 03-21-2014, 04:09 AM
  #11  
kzimmerm
Junior Member
 
Join Date: Dec 2004
Location: Montrose, NY
Posts: 13
Likes: 0
Received 0 Likes on 0 Posts
Default

Good day all. Last night I started programming my DX9 for one of my 6 servo gliders. I breezed through the basic programming until I got to the flaps. Im guessing the issue is I'm missing a step. No matter what I did I could not get the flaps to move. The manual was not clear. Could someone identify the proper steps for programming the flaps? When in Monitor mode I don't see any movement indicated on the 2 channels assigned to the flaps.

Kurt