RCU Forums - View Single Post - Carf - Models J-10 build thread
Thread: Carf - Models J-10 build thread
View Single Post
Old 11-03-2014, 10:37 PM
  #53  
Airforce7
My Feedback: (31)
 
Airforce7's Avatar
 
Join Date: Feb 2004
Location: Brentwood, CA
Posts: 1,123
Received 18 Likes on 17 Posts
Default
Bob,

I just measured the retract units.

Nose = Behotec C40-R
http://www.altecare.com/c40schematic.jpg
http://www.altecare.com/c40withservosteering.jpg

Measured (hole to hole center) 38mm x 28mm

Mains = Behotec C50-B
http://www.altecare.com/c50dimensions.jpg

Note: these are fire wall mount style which I measured (hole to hole center) to be 50mm x 30mm. About 8mm shorter than the standard C50 dims.
Airforce7 is offline  
Reply Like