RCU Forums - View Single Post - 3W Bearcat with Moki 300
Thread
:
3W Bearcat with Moki 300
View Single Post
03-04-2015, 07:34 AM
#
54
rbgetz
Join Date: Oct 2013
Location: Northern Illinois
Posts: 396
Likes: 0
Received 8 Likes on
8 Posts
I’m trying to make a final decision on the tail wheel assembly. I’m using the Sierra tailwheel, but concerned that once I glue & screw that in place, how would I access/remove the tail wheel assembly if maintenance is required. It’s is a hard to reach back and the actual door opening is too small to get into to work on tail wheel if required. I just really hate closing things in that may need to be accessed later. So... open to ideas since I’m not an expert builder. In my pictures below, for now I made it so you can reach back in the fuselage and unscrew the tail off the bulkhead and pull the whole thing out. I think this might work… I’d be interested in what others have done or are thinking of doing.
Attached Thumbnails
Reply
Like
rbgetz
View Public Profile
Send a private message to rbgetz
Find More Posts by rbgetz
View iTrader Profile