MD500 Multiblade
Hi,
New problem... I just finished building my 5 blade Copter/X 450SE to assemble it into my MD500.
I moved the tail servo to almost underneath where the boom starts. It was flying 2 blade perfectly. Once I moved the tail servo to the new position, I had to add a longer rod to the rudder. I start the heli with a throttle curve of 0, 80, 80, 80, 90 and the startup it spins very wild and hard til I control the tail. Once I add throttle the I have to add right stick to control it. Once I have it in hover the tail goes wild right.
Any ideas?