Brett, Dude, we are both in a minefield.
We're dead.

I am trying to find a funny way of saying this, but I am too tired.

So, in my last post I wrote these exact words above the photo...

Here is the diagram I was using when I was trying to install a servo on my pershing using a 4YF.
The only difference was I used the camera hold module instead of a delay.

CAN YOU READ?!?!?

(Just pretend the underline bold italic font is a really loud and annoying computer tech voice with a lisp and a small spittle flew on your new guayabera shirt)

That photo is from 2007, and I have no idea who wrote the original post.
I got it off the HEAT site a few years ago.

This time imagine a low pitched jovial voice...
Last time when you told me about the photo delay module, I bought it, and I tried it.

I think I tried it with a self centering stick and without.
I think when I tried it without the self-centering, the elevation noise ran continuously.
I think when I tried it with a self centering, the servo/barrel jumped when I fired, like it was getting a jolt of juice.
I think I also tried it with one delay, and even maybe two delay modules in sequence with the photo delay.
I think.
I think.

I think I really don't know what I was doing wrong, or maybe I was over-thinking/over-analyzing it.

All I can really remember is that we pretty much had this same exact conversation before.
And I sold all that stuff out of frustration.