RCU Forums - View Single Post - acceleration error
Thread: acceleration error
View Single Post
Old 08-10-2015, 05:22 AM
  #6  
aquaskiman
My Feedback: (46)
 
aquaskiman's Avatar
 
Join Date: Dec 2001
Location: Sedalia, CO
Posts: 1,157
Likes: 0
Received 2 Likes on 2 Posts
Default
Originally Posted by TommyWatson
I have a new Wren Jubilee 80. When I advance the throttle slowly it spools up OK. If I slam the throttle open I get ""Acceleration Error"" on the display. I set the acceleration delay to 15 (it was set to 5). After I get this error the engine will not respond to the throttle.

Any ideas what is causing this.
Regards
have you tried increasing the stabilization delay
aquaskiman is offline  
Reply Like