I did start it up last night and stood behind it a few feet and can see a nice flame all the way around as it idles there. I did go back to the last settings from PST when turbine was sent in for bearing change. The gentleman I bought it from flew this turbine at 7000 elevation. Maybe that's what's the problem so I reset all ramps to what PST used on the test stand and will go from there. He said it ran great and only a few flights then it sat for about 2.5 years. The more I start it the better it gets. Maybe getting bearing nice and lubed. Will run it tomorrow with new ramp values and see how it goes. Was just looking for another probe as a spare just in case. Dreamworks sells them but with a Jr connector 3 wire. This uses 2 wire. Any other turbines use this kind of temp probe?