Hey Benny,
Thanks for that information. I know there is a set screw in there somewhere, but those things are very small for me to see. You have to take everything apart to get to that set screw, and to tell you the truth, I just do not have the motivation to do any more than I have to do - especially on small stuff that is hard to see and hard to manipulate with old fingers. With my Barrage, the easiest thing to do was to dab a bit of foam tac glue on each pin end, and so far so good.
Horizon is now selling the newer version Barrage in kit form which really is in very small pieces. All those little pieces would be a real challenge for me, but I think I could manage it if I did it in a whole lot of one-hour sessions. However, I already have my original Barrage which is working just fine, so I really do not need to buy another. If my original Barrage goes bad, however, I think I would make a stab at the new Barrage kit.
Best wishes,
Dave Wile