Poor planning on my part caused a short delay in building. I needed some PVA to help install the tailcone and had to order some, will be here tomorrow. In the mean time I decided it needed a bath to remove the PVA mold release. When this stuff gets wet its slipplier than greased snot. Afterwards I cut the canopies except for the rear one and will get it tomorrow. As the tail group build continues I will be able to work on the canopies as glue cures. I hate to admit it but an error cutting my stab sheeting will need to be corrected before tail group is finished. Rectrocranial inversions will add 2-3 days to my completion of the stabs and tail. Read the instructions CAREFULLY! Still a great kit and I am really excited about it. It's big when you plug in the stabs!