RCU Forums - View Single Post - Q500 wing with no SPAR ??
View Single Post
Old 04-27-2019, 07:10 PM
  #8  
speedracerntrixie
My Feedback: (29)
 
speedracerntrixie's Avatar
 
Join Date: Jun 2010
Location: Happy Valley, Oregon
Posts: 8,263
Received 92 Likes on 85 Posts
Default

Great post! Most wing failures I have seen did not happen at dead center but usually just outside the fuselage. For that reason I always apply the cloth to extend at least one fuselage width past the fuselage. My last two designs have rather thin wings so a vertical wing joiner of Divinicell with 3.6oz bagged front and back. The joiner is flush to the exterior of the wing skins so that when the center section is glassed the glass has a connection to the joiner. Very light and strong.