View Single Post
Old 09-23-2019, 03:22 PM
VincentJ's Avatar
Join Date: Mar 2011
Location: Peterborough, NH
Posts: 4,449
Received 53 Likes on 48 Posts

The hinge blocking for the flaps and ailerons have all been installed in the wing. I can start on sheeting and closing off the wing now.

In preparation for sheeting, I had to run all of the wires in the wing. With flaps. ailerons, retracts and navigational lights to operate, the amount of wiring inside the wing is substantial.

Close up of the blocking that will hold the servo access hatch. Four 2-56 cap head screws will secure the hatch to the wing. Note the cutout to facilitate access the RDS (Rotary Drive System) set screw...

Last edited by VincentJ; 09-24-2019 at 06:40 AM.