RCU Forums - View Single Post - Cleaning up an old glow engine

04-17-2020, 11:30 PM

#22

bigtim

My Feedback: (13)

Join Date: May 2004

Location: san francisco, CA

Posts: 4,177

Likes: 1

Received 2 Likes on 2 Posts

My 4 stroke rebuild new crank bearings, timing gear bearings, connecting rod and pin, it was so gummed up and rusty it would hardly turn over, cam bearings were seized which is not common, got it on a deal from eBay and now it’s fresh hopefully I can get a run in tomorrow on my stand to dial in the carb because I have 2 more to go through and rework hopefully not as much as this one life is good One note the rebuild is fairly inexpensive the costly part was the rod and pin which was 35 bucks

Reply Like