RCU Forums - View Single Post - Configuring UART2/I2C on APM 2.8
Thread
:
Configuring UART2/I2C on APM 2.8
View Single Post
08-27-2020, 02:36 PM
#
1
Dmpanhead
My Feedback: (
1
)
Join Date: Mar 2009
Location: Farmingdale, NJ
Posts: 12
Likes: 0
Received 0 Likes on 0 Posts
Configuring UART2/I2C on APM 2.8
Does anyone know how to configure UART2 on an APM 2.8 board? I need Tx, RX, +5v and ground. I would need pin out and board mods and possibly firmware/software mods
Reply
Like
Dmpanhead
View Public Profile
Send a private message to Dmpanhead
Find More Posts by Dmpanhead
View iTrader Profile