RCU Forums - View Single Post - are these blades any good for cp pro?
View Single Post
Old 04-26-2021, 09:04 PM
  #15073  
Aframomum
My Feedback: (10)
 
Join Date: Jun 2004
Location: Orlando, FL
Posts: 1,543
Likes: 0
Received 0 Likes on 0 Posts
Default

Hi guys,

Feeling much better now and am back to work. Things are slowly returning to normal. My wife had her second Pfizer shot and it hit her rather hard for the past 4 days. At least this is behind us now.

I had a bit of a revitalization with my trains the past week and got back to working on them. Had to clean up all my track so I could get a few of my loco's running again. I also was able to get some much needed work done on my son's section - got most of the yard done. It looks good and now I just have to wire it up to test out everything. I also looked on youtube to see about making my own cleaner car out of an old boxcar. Some of my sections of track are very hard to reach with a cleaning pole so I figured make up a DIY cleaning car and run it around the layout a few times to clean up that track.

That's about it for now,

Mark