RCU Forums - View Single Post - 3D Print Project SSYMS 80 ton 1/16th Scale
Old 09-16-2021, 07:58 AM
  #77  
Shark27
 
Shark27's Avatar
 
Join Date: Jul 2009
Location: St. Petersburg, FL
Posts: 523
Likes: 0
Received 17 Likes on 12 Posts
Default

Will,
I was going to print one of those KofII for display purposes only, I am sure a motorized one could be used to move the empty SSYMS rail car around, once loaded however, may be too much for it to handle.
Even with the electric motors installed to drive it, there would definitely need some serious ballast on board to move a loaded SSYMS with an RC tank in place.
Steve