RCU Forums - View Single Post - 1:8 dukw
Thread
:
1:8 dukw
View Single Post
10-08-2021, 08:53 AM
#
8
patmat
Join Date: Nov 2004
Location: Temecula, CA
Posts: 244
Likes: 0
Received 24 Likes on
19 Posts
And what about that transfer case??
I looked at available t-cases, like the one in the HG P602 MRAP, but no one has two rear outputs.
Time to design my own.
I salvaged the gears (Mod1 sintered steel, nice) from the P602 t-case, and will add a couple more from SDP-SI. Case will be printed, and I'll use simple flanged Oilite bushings. No need for a lot of ball bearings at this speed!
My design has 1.9:1 reduction, and I'll mate it to a gearmotor with 11:1 reduction, along with 2.9-ish at the axles. And it's set up with both rear outs turning the same direction.
HG P602 t-case
2-speed, which I won't bother with
My layout with 2 rear outs. Need to add case screws and mounting flanges.
Reply
Like
The following users liked this post:
herrmill
(10-09-2021)
patmat
View Public Profile
Send a private message to patmat
Visit patmat's homepage!
Find More Posts by patmat
View iTrader Profile