RCU Forums - View Single Post - Using a 5volt vtx on an Arkbird
Thread: Using a 5volt vtx on an Arkbird
View Single Post
Old 01-10-2022, 04:44 AM
  #1  
singlechannel
 
Join Date: Feb 2010
Location: ThornlieWA, AUSTRALIA
Posts: 21
Likes: 0
Received 0 Likes on 0 Posts
Default Using a 5volt vtx on an Arkbird
I have plugged my 5 volt vtx into the 5volt tx pins on my Arkbird OSD. My goggles show their picking up the vtx signal but not showing a picture. Wondered if I could continue using the 5volt and ground pins but use the signal

pin from the 12 volt video out plug.
singlechannel is offline  
Reply Like