RCU Forums - View Single Post - "Flight Of The Intruder" Grumman 1:5.5 A6 Intruder Redesign & Build
Thread
:
"Flight Of The Intruder" Grumman 1:5.5 A6 Intruder Redesign & Build
View Single Post
05-27-2022, 08:11 AM
#
168
Ron S
My Feedback: (
2
)
Join Date: Dec 2001
Location: Fort Worth, TX
Posts: 2,233
Likes: 98
Received 205 Likes on
125 Posts
These comments below, from a 2012 Model Airplane News article about the MiBo A-6 Intruder model... Courtesy of the internet...
The formers are made with nomex/carbon to reduce weight. The landing gear is made from Aluminum/Titanium again to reduce weight. The plane is just under 1/5-scale and weighs 55lbs. dry. It uses a B300F turbine with the power dialed back. It is a single engine with a bifurcated pipe made of stainless steel and titanium. The model has functional slats and flaps, as well as pylons with ordinance. Probably the toughest part of Mike’s project was the landing gear and the main doors which are so large....
Reply
Like
Ron S
View Public Profile
Send a private message to Ron S
Find More Posts by Ron S
View iTrader Profile