RCU Forums - View Single Post - 1/4.5 T-38C Talon scratch build
Thread
:
1/4.5 T-38C Talon scratch build
View Single Post
03-20-2023, 09:46 AM
#
285
invertmast
My Feedback: (
23
)
Join Date: Dec 2003
Location: Capon Bridge, WV
Posts: 8,198
Likes: 27
Received 225 Likes on
116 Posts
all of the doors and speed brakes are done… sort of.
I also have the flap drives and hinges all assembled and hysol’d.
same goes for the rudder drive.
the two piece inlets are also done:
and the inlet ducts installed and rough shaped.
nose gear structure is installed:
and the vertical stab tip antenna.
The speed brakes have begun to be hinged:
and all of the stuff under the engine hatch was put in place once again to verify the tailpipe measurements. Its definitely a lot of stuff in a small area.
Reply
Like
The following 2 users liked this post by invertmast:
Viper1GJ
(03-20-2023),
yeahbaby
(03-20-2023)
invertmast
View Public Profile
Send a private message to invertmast
Visit invertmast's homepage!
Find More Posts by invertmast
View iTrader Profile