RCU Forums - View Single Post - U-C-D 3D question
Thread
:
U-C-D 3D question
View Single Post
01-20-2004, 03:35 PM
#
6
Checklst
Senior Member
Join Date: Dec 2002
Location: Alpharetta, GA
Posts: 792
Likes: 0
Received 0 Likes on 0 Posts
RE: U-C-D 3D question
Did not want to start a new thread for my UCD, I did my first flight (on a 3D)on mine today and it flew wonderful. I was a little unsure how the twin tank(4oz header on centerline with carb) and a 6oz over the wing balance point. The engine is a new TT91fs running 30% synth no caster I was amazed that it would hover at 1/2 throttle with a 15x4 APC and she was running so rich she looks like she is running a smoke system can't wait to lean her out. She had gobbs of pull out power.
Wow take about a slow landing plane and will do anything, she came out 7lb even with the twin tanks and a 1100ma battery. Hear are few pre flight Pict(I did not like the fact cover job)oh I did a few cutouts and lighting holes in the fuse
Attached Thumbnails
Reply
Like
Checklst
View Public Profile
Send a private message to Checklst
Find More Posts by Checklst
View iTrader Profile