RCU Forums - View Single Post - PPG/Model Master compatability
Thread: PPG/Model Master compatability
View Single Post
Old 06-19-2002 | 11:01 AM
  #4  
DavidR
Senior Member
My Feedback: (1)
 
Joined: Dec 2001
Posts: 3,241
Likes: 0
Received 0 Likes on 0 Posts
From: Oxford, MS
Default PPG/Model Master compatability
Matt,

It is 2060 flex n flat. Great stuff, I mixed a little 2021 in with it for an egshell finish but I am going to shoot some straight out of the can this weekend. It uses the DCX 61 catalyst, and the same reducer......as usual thinned way out.

DR

BTW if you let it set for more than a couple of days and then apply ANYTHING to it make sure and lightly scuff it up with a very fine (grey) scothbrite pad.
DavidR is offline  
Reply Like