MPX IPD 9 ch. problems - NIB
I got my IPD9 channel a few days ago and played with it today. Everything worked fine until I programmed failsafe. Upon using the supplied connector to set the failsafe position for a throttle servo, now the servo starts oscillating everytime I give it input. It happens on all channels and I have tried more than one servo, a few 5945s.
If the servo is in throttle, when i move the throttle stick, the servo moves to its new position but will then start oscillating about 1/2" total travel for 2-3 seconds and then stop. I won't be touching the stick at all during this time.
This is very awkward. I was looking forward to using this new RX in my next plane. Mike, please contact me directly to resolve this issue.
Has anyone else had this occur? Is there some trick that fixes this?
Thanks
Craig