RCU Forums - View Single Post - What Finishing order is best when building a Profile and Why?
Thread
:
What Finishing order is best when building a Profile and Why?
View Single Post
06-26-2004, 10:20 PM
#
24
Sport Flyer
Senior Member
My Feedback: (
10
)
Join Date: Dec 2001
Location: Portage La Prairie, MB, CANADA
Posts: 406
Likes: 0
Received 0 Likes on 0 Posts
RE: What Finishing order is best when building a Profile and Why?
Hmmm. I just glued the wing in on my Sig Fazer. If I had read this first I probably would have covered it first, but .... covering my ProTwister assembled last year wasn't so bad.
As far as the wing joint goes, I used thin CA first, followed by medium to help with the gap filling and finally used slow cure epoxy mixed with mircroballoons for my fillet and a wetpinky to smooth it out. The instructions call for four pieces of fiberglass cloth to reinforce the joint but I'm pretty sure the fillet will be more than enough - if that lets go I'm sure to be doing some rebuilding anyways!
Attached Thumbnails
Reply
Like
Sport Flyer
View Public Profile
Send a private message to Sport Flyer
Visit Sport Flyer's homepage!
Find More Posts by Sport Flyer
View iTrader Profile