RE: Cloud Bound 4
I'm removing the covering to take out some weight in the tail section - by various methods - it's now over-built because I didn't see Ray's tips until I was done with the fuselage.
Oh, another couple things -
1) It may have been just my setup, but the pushrod-tube assembly provided in the kit gave a vague response near center (around 1/8" total play). I replaced with CF pushrods.
2) Take some time to think about how your going to tie the control to the tail pieces, my setup is ok, but I think there something better out there.
3) The joiner between the tail sections and the fuselage are not that obvious, take some time here to make it look good - there will be shaping required.