RC10GT just got it put togeather and tweaked out, OS .12 cv-s engine non-pull.

Drop it on the starter box (used after run oil on engine) engine spinning good on box.

Put fuel in car and drop on starter box, holded my finger over carb, tipped the car, everything.

It won't pull the fuel over to the engine so it will start.

Any ideas on why this would occur. All lines are correct, engine turns over no problem, just doesn't fire because fuel doesn't pull through the line...

Starting to piss me off. [>:]

Help is aweseome and greatly appreciated!

chAz