Hello everyone!

After reading these forums for quite some time, I finally decided to take the plunge and get started on learning to fly. I purhcased a Sig Kadet LT40 and a Futaba radio to get started. The LT40 was an ARF and after spending some time putting the pieces together, I am finally at the point where I am installing the radio equipment in the plane. My question is, when I plug the servos in to the receiver and turn on the radio and receiver, some of the servos seem to "chatter" even when i have no linakage connected to the servos, not even sevo arms, is this normal? The receiver is the Futaba R148DF and the servos are Futaba S3004's.

Any input you can offer will be gretly appreciated.

Great forum by the way!!

JesseV.