RCU Forums - View Single Post - BUILDING your own VPP Setup
Thread
:
BUILDING your own VPP Setup
View Single Post
04-27-2005, 11:40 PM
#
15
Levi_Jordan
Senior Member
My Feedback: (
21
)
Join Date: Jul 2002
Location: Cheney, WA
Posts: 587
Likes: 0
Received 0 Likes on 0 Posts
RE: BUILDING your own VPP Setup
Another shot. You can see the coller on the back of the motor in this one. This is needed to keep the shaft from pulling out of the end bell under the MASSIVE POWER!
Reply
Like
Levi_Jordan
View Public Profile
Send a private message to Levi_Jordan
Find More Posts by Levi_Jordan
View iTrader Profile