RCU Forums - View Single Post - Bridi fiberglass fuse construction?
View Single Post
Old 08-31-2005, 07:41 PM
  #8  
N1EDM
My Feedback: (2)
 
Join Date: Jul 2002
Location: Brockton, MA
Posts: 4,290
Received 7 Likes on 7 Posts
Default RE: Bridi fiberglass fuse construction?

Thanks, Duane.

I'll leave the fuse as is, then. It sounds like fuse was built that way at the factory. I don't think I'm going to do any better than Joe Bridi, so I'll leave it alone. If it's good enough for him, who am I to argue?

I really want to get my feet wet with this model. I want to try a few things, but don't want to get mired down in areas that I know nothing about... am working on a way to make Scale hinges. I could always use the old fallback of Robarts, and not too many people would notice, I don't think. Still, Dave Platt has a neat way of making them out of G-10.

Thanks again for the reply!

Bob