9C - change from 72MHz to 36 MHz
Hi
I am an Aussie living in China. When I purchased my Futaba 9CH 3 years in Guangzhou ago I could only get 72MHz. This was OK as this is supported in China. Now I am getting closer to going back to Australia I need to convert to 36 MHz and eventually sell of my 72 Mhz Rx's.
I purchased the Futaba FP-TP-FM 36 MHz Module including a Tx crystal (Type 36-1), two 36 MHz Rx's (Hyperion) and crystals.
Is changing the Tx frequency just a matter of swapping the Module out of the back of the 9C and using a 36 MHz Rx on the same channel?
I have done this but get no response at all from the servos plugged into the Rx.
I have NO trouble with the std 72MHz Module and Berg Rx's. What to try next?
Please advise
Jeff.