View Single Post
Old 11-20-2005, 09:30 PM
  #5  
cellophane
Junior Member
 
Join Date: Nov 2005
Location: - , SINGAPORE
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default RE: RX problems; Newbie needs help

ORIGINAL: exeter_acres

there are exceptions... but for the most part, you need to use the crystal from the same brand as your Rx
heyz....wat if im usin the crystal from my MCU chip to connect up to my reciever...how do i match it with my transmitter?
is the brand still important?
how do u find the range of the receiver and transmitter??

im workin with PIC18F2431...so any recommandations for the Rx and Tx??

ok...im realli realli new at these...wat exactly are the channels on the transmitter for??
if i have four motors to control how many channels should i have for my Rx/Tx??