3D switching help needed.
 

Hi everyone,
I just bought my first 3D capable plane today. Being a new/intermediate flyer I'm just hoping to fly it in Genaral flight mode for a while. The plane is a Parkzone VisionAire AS3X and I'm using a Spektrum DX6i transmitter that I also just bought. So far I've set all of the Dual Rates and Expos, set servo travels to 125%, sub trims to neutral all as per instructions in manual. The problem that I have is that it says to enable/ and I assume disable 3D flight mode using the 5/aux switch. As there is no switch labeled thus can anyone familiar with the Dx6i please help me. Thanks heaps.
<br type="_moz" />

RE: 3D switching help needed.
 

As the manual tells you: it is the gear switch on the top left corner of the DX6I. In sport mode the RX dramtically reduces the elevator throw and offers only a small amount of 3X correction. I'm not real sure that this mode is very helpful. ( 'Course I'm a 3D guy and can't stand not seeing at least 60 degrees throw in preflight.) This plane is very responsive on all control surfaces and a blast to fly. Although it feels light to pick up and hold, it feels heavy in the air and IMHO isn't a very good 3D plane. The AS3X system works amazingly well, on my first landing (in a 15 knot cross wind) I swear it crabbed into the wind on it's own. I think my PA AddictionX has spoiled me as far as 3D planes go, but I'm keeping my Visionaire because it is so much fun to fly!