Vertigo 3D
 

Just to let everybody know that the new Vertigo 3D's are now being shipped out of radical r/c from Dave Thacker. I have put extensive Design into this model and has proven itself at all fly-in I have went to. This 26" 4 Channel airplane will Tourqe Roll, Harrier with extreme ease!, Harrier roll, Blenders, pop-ups, water falls, etc... I can do everything with it that I can do with a 40%, with a lot less invested. The whole outfit includes: 1 laser cut kit, 1 black diamond motor, 4 servo's, 1 li-poly 3 cell, 2 9.4.7 props, 1 y-harness, 1 plantraco reciever, 1 extension. $238.00 for the electronics, and $59.00 for the kit. An inexpensive, fun to fly, 3D airplane. You can e-mail Radical R/C @ [email protected],
or check out his web site www.radicalrc.com and got to rc electric kits. This airplane will rocket vertical at the begining of the pack and mid pack, by the end of the pack (20 minutes later) you can still harrier around. If you have anymore questions you can e-mail me at [email protected] Thank you all and have a great week.



-Jason Noll
Designer of the Vertigo 3D

RE: Vertigo 3D
 

I would also like to add that I am going to be doing turn key vertigo's for anybody who is interested. There is a line.........


Thank you!
-Jason Noll

RE: Vertigo 3D
 

Hey Jason -

At the XFC, Bill told me that you were using a special covering film that cut down on the weight (but was a PITA to use). What is it and where do you get it.

BTW - are you and your dad coming to the IMAC "Chicken Wing" in Columbus?

Keith Sessions

RE: Vertigo 3D
 

The covering is called Nelson Light Film. It is a pain in the %^& to use, but the results are great! You can get it from Dave Thacker @ radicalrc.com Is the "Chicken Wing" a contest, fly-in? EtC?? you can email me directly at [email protected].

Thanks -Jason