new to 3d info needed
i have a pair of 3 bladed 13-8 props, does anyone know what type of brushed motors, esc, gears, and battery packs i could use to make a twin motor 3d plane. i am thinking a wing span of about of 60 inches. the wieght does not really matter to me as long as it can hover pretty well. or if this is not a good prop to us are there other sugestions.
|
RE: new to 3d info needed
Hi
I would rather buy one brushless setup then two brushed ones.... if chooseing brushed go for a 2 bladed prop, they are much more efficiant. |
RE: new to 3d info needed
I am also in the process of building a vtol...but mine has 4 motors...it doesnt have any wings..it will run on 4 300 speed edf 5 blade ducted fan units.....i expect to use only 4 ch...im hoping for it to look like the bell x-22 2 channels used to tilt the rotors on each side and the other 2 to power the rotors on each side...if u have any ideas or suggestions, they would greatly apreciated.
|
RE: new to 3d info needed
i would like to know how exactly you will control you are model
|
All times are GMT -8. The time now is 10:41 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.