Tensor flight video
 

Hideho all,
Sorry I haven't gotten this posted earlier, I've been bedridden with pnemounia the last week or so. I had a friend do the editing, not my first choice of music, I apologize to all whom it offends in advance.
Tensor, Eflite 370 1080KV, CC-10, Apogee 830 3sp, GWS 10X4.7, HS-55's, GWS 6ch..all up weight 10oz on the nose.

Sorry, bandwith limit reached.

RE: Tensor flight video
 

Great video. Nice flying.

I see you are using a 6ch reciever, are you using dual aileron servos, and if so, how do you have them mixed?

RE: Tensor flight video
 

HAven't had the need to mix anything......I did have flaperons on my Ulti, just for Oh so cool elevators....

RE: Tensor flight video
 

toooooo sweeeeet, ok now I have to get my credit card out again.

RE: Tensor flight video
 

Excellent Flying Mike, I,m working on a Sorta Tensor right now and this gives me that much more incentive to push foward with the project. I will be using the Himax 2808-980 Outrunner on it with all the other electronics the same as yours.Thanks For The Video Yogi:D

RE: Tensor flight video
 

How it going Mike, hope your doing better..Long time no see bud..;)
Tensor in an awesome plane w/o a doubt, the outrunner is a very efficient powerful motor option..for short burst vertical. Knife edge is extremely nice as well as nice axial rolls and most anything. I see your honing on on this one..[8D]

RE: Tensor flight video
 

Excellent. Is your CG at the recommended setting or did you change it for a furthur aft CG?

RE: Tensor flight video
 

We all moved ours back to 3" instead of the recommended 2 1/4-2 1/2" thats recommended. it flys MUCH MUCH better. Doesnt drop the nose on slow speed landings.

If you notice in his video, at the end with the landing how it nosed over....im betting he had the CG set in the recommended spot. If he moves it back, it wont nose over on the landing like that.

RE: Tensor flight video
 

Nice video of flying the Tensor, looks good. i just picked one up today at the Hobby Shop. I actaully went there to get some stuff I needed to start my E-flite Ultimate kit, but I'm putting this one together instead first. It should be flying tomorrow. Cannot wait! Im using an Axi 2208/34 and 3 cell 1320TP. Its the same setup thats in my shocky except I use the 860s.
Ryan

RE: Tensor flight video
 

Use the 860's Ryan...