thrust angels
 

Being a newby to 3D just wondering if i am going down the right track here for a while now i have been adjusting motor angels so when the plane leaves my hand into a hover all control sufaces are straight except for right aleron input .
The extra 300s done this straight away and i can see the motor mounts are pre set down and to the right .
Iv all so had to ucd flexys both iv had to adjust motor mount down other wise it takes a lot of down alervator to stop it comeing back at you in hover.
The yak 54 dident need any adjustment pre set i take it,am i going down the right track here for good set up for 3D
Thanks beaggs