Aileron Mixing into Split Elevator
08-27-2003 | 03:04 PM
#1
Thread Starter
Joined: May 2003
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
From: Houston, TX
Aileron Mixing into Split Elevator
Folks,
I would like to create a mix on my JR 8103 that enables the split elevator to move like ailerons. I want this to assist in controlling the rock in a harrier. Unfortunately, I'm unable to get this mix working because I already have ELEV mixed to AUX3 due to the split elevator.
Any ideas?
Thanks!
I would like to create a mix on my JR 8103 that enables the split elevator to move like ailerons. I want this to assist in controlling the rock in a harrier. Unfortunately, I'm unable to get this mix working because I already have ELEV mixed to AUX3 due to the split elevator.
Any ideas?
Thanks!
08-27-2003 | 06:06 PM
#3
Thread Starter
Joined: May 2003
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
From: Houston, TX
Aileron Mixing into Split Elevator
Already tried that.
AIL and AUX1 are used for ailerons.
ELEV and AUX3 are used for split elevator.
To get split elevator to work I mixed ELEV -> AUX3 on mix5 so the trims work.
The difficulty is that to have this mix work you need:
AIL -> Aux3
Aux1 -> Elev
Due to the split elevator, I also have ELEV -> AUX3. So the programming ends up being recursive.
AIL and AUX1 are used for ailerons.
ELEV and AUX3 are used for split elevator.
To get split elevator to work I mixed ELEV -> AUX3 on mix5 so the trims work.
The difficulty is that to have this mix work you need:
AIL -> Aux3
Aux1 -> Elev
Due to the split elevator, I also have ELEV -> AUX3. So the programming ends up being recursive.
