RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   3D Flying! (https://www.rcuniverse.com/forum/3d-flying-82/)
-   -   help with my hype3d (https://www.rcuniverse.com/forum/3d-flying-82/1313863-help-my-hype3d.html)

caliber302003 11-29-2003 06:01 AM
help with my hype3d
 
hi all ive ran into a bit of a problem on my hype3d. what it is i cant seem to find out which way the tank goes up as there is such ample space do you guys just bung it in and fill with foam or is there some sort of way it has to go some pics would be a great help

many thanks :D

stomper 11-29-2003 09:15 AM
RE: help with my hype3d
 
ORIGINAL: caliber302003

hi all ive ran into a bit of a problem on my hype3d. what it is i cant seem to find out which way the tank goes up as there is such ample space do you guys just bung it in and fill with foam or is there some sort of way it has to go some pics would be a great help

many thanks :D
I just cut 1/8" lite ply to the inside width of the fuse about one inch wide, two on top and two on the bottom with just enough space to shove some foam between tank and lite ply. This way you can control the hight of the tank to the carb.

This an awesome plane!!!! Best of luck with yours.

Professa 11-29-2003 07:29 PM
RE: help with my hype3d
 
depends what engine you have - if it is a ys 63 then it dont matter

YNOT 11-29-2003 08:49 PM
RE: help with my hype3d
 
Find the lightest foam you can and put one piece on the bottom and one on the top.

You gonna luv this plane.


All times are GMT -8. The time now is 09:32 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.