Help !!!!
 

Ok, here is the deal. I have a 9c radio and 5 hi-tech 5925mg digi servo's(100 oz's of tork). I am looking for a new 3d ship. A buddy has a wild hare 28% 540 i am thinking about but the directions say 120 oz servo's on the wing and 180 oz's on rudder. A new rudder servo does not bother me but i dont want to have to get two ail servo's and a rudder servo.

Plane MUST 3D !! No fun fly's please. I was kinda hoping it would be a little on the big side.
I did find a Fantasy, AWSOME plane.

Yes i need motor and airframe. Was hoping some one would have a few idea's.

Thanks

RE: Help !!!!
 

Those 5925 have plenty enough torque for that wildhare 540, run them on a 6 volt pack & you will be fine.
Gil

RE: Help !!!!
 

Didnt know that digi could handle 6v. Sweet !!!

Any body have first hand exp on this plane????

RE: Help !!!!
 

You should check www.downonthedeck.com. They have a lot of information about it!!

RE: Help !!!!
 

ewww

RE: Help !!!!
 

Thanks guys! I read up on it. Nice plane!!

RE: Help !!!!
 

Check the sub forum under giant scale. Also Krayzc is doing a most detailed building report in arf or rtf. Check it out. Joe