RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   3D Flying! (https://www.rcuniverse.com/forum/3d-flying-82/)
-   -   3-D fly in and how to clinic (https://www.rcuniverse.com/forum/3d-flying-82/326084-3-d-fly-how-clinic.html)

Dead Plane Flying 10-22-2002 12:35 PM

3-D fly in and how to clinic
 
Hey guys, we are having a 3-D fly in and" how to" fly 3-D down here in the still warm sunny South Nov. 8th and 9th. There will be lots of open flying with a 3-D clinic on set-up and how to perform the most popular 3-D maneuvers. At noon, there will be 4 minute freestyle flights for anyone who would like to participate. State of the art sound system with lots of great sponsors for give aways. This is a non competition event being held by The Extreme Aerobatic Club just to promote 3-D flying. It's being held at the Point Clear Polo Grounds in Fairhope AL. For more info, contact me Wes Batson at [email protected] or go to BlaineAustin.com. Mike Sauls, Blaine Austine, and Joey Hamilton are just a few of the pilots that will be attending.

Jeff Pfeifer 10-22-2002 02:36 PM

" Taking it to the EDGE" 3-D fly-in Polo Grounds Fairhope, AL
 
Hello all,
If you need any more information on this event go to www.blaineaustin.com and he has all of the information on this event under the Extreme Aerobatic Club. I also am planning on attending this event.

Jeff Pfeifer

SLC 10-26-2002 06:48 PM

3-D fly in and how to clinic
 
If you were unable to attend the 3d flyin in Chattanooga earlier this year you you need to make plans to attend this event. The Extreme Aerobatic Club is a great group of guys willing to help you with questions about building, setup, and technique. The show will be exciting. Hope Blaine has better luck than he did in Chattanooga. It was a shame to see his Carden Edge cartwheeling to destruction on a low knife edge pass. Hope to see ya'll there

SLC


All times are GMT -8. The time now is 06:33 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.