Cannister on CH Vision
 

How is the proper way to attach the cannister on a Chip Hyde Vision? I have never done a cannister installation and am not sure how to secure it in the tunnel area.

Thanks,
Allan

RE: Cannister on CH Vision
 

You have to make a slot in the belly pan to secure the mount. After the mount is installed, the slide in the belly pan. Measure twice, cut once. The cannister is much quieter than the stock DA muffler.

R/C Foolsih

RE: Cannister on CH Vision
 

You have to make a slot in the belly pan to secure the mount. After the mount is installed, then slide in the belly pan. Measure twice, cut once. The cannister is much quieter than the stock DA muffler.

R/C Foolsih

RE: Cannister on CH Vision
 

What do you make the mount out of so it won't be affected by the heat?

Thanks

RE: Cannister on CH Vision
 

The mount comes with the cannister. It is a bracket that gets bolted to a former with a piece that has a rubber snubber with an o-ring that holds the cannister.