Servo help?!?!
 

I am going to get this plane http://www.horizonhobby.com/Products...ProdID=SEA5025 with a YS 1.40. I plan on doing all the aerobatics and maybe get into 3d as I get better.

What servos do you recommend. I want them to be good but I dont really want to spend a lot of money, since I am only a teenager without a job!! I was looking at the Jr st 126mg for the other plane I was looking at before I found this one. I dont know if those will work or not.

Please leave some comments

Thanks

Chris

RE: Servo help?!?!
 

I dont see how you could go wrong with either Hitec 645MGs or the JR 125MGs

Both are a quality metal gear servo that you will be able to use in larger planes as you move up as well.

RE: Servo help?!?!
 

Can't beat a 645 for only $35. You could probably get by with a 645 on the rudder and 635's everywhere else. HS225 for throttle.

RE: Servo help?!?!
 

Can get 645s here for $29.99
http://www.obrienhobbies.com/hihshimegese1.html

RE: Servo help?!?!
 

I agree with sinergy, 645mg is a good servo for all surfaces in 90 size planes and HS81mg for throttle is what I use.

RE: Servo help?!?!
 

I think the 635 are carb gears and I wouldnt use carbonite past 40 size planes.

RE: Servo help?!?!
 

hate to burst your bubble my friend but a YS140 will shake this model to bits.

RE: Servo help?!?!
 

Really?, Then the YS 1.10 I guess.

RE: Servo help?!?!
 

For the throttle I was thinking just a cheap $10.00 servo is there something wrong with that?