RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   3D Flying! (https://www.rcuniverse.com/forum/3d-flying-82/)
-   -   Extreme Flight Extra 58" (https://www.rcuniverse.com/forum/3d-flying-82/7158735-extreme-flight-extra-58%22.html)

sdstick06 02-29-2008 10:35 PM

Extreme Flight Extra 58"
 
I know there has to be a thread on this plane... can't seem to find it... can someone tell me where I can find it?

Michaelh 03-01-2008 01:48 AM

RE: Extreme Flight Extra 58"
 
We need to make one? Ill have mine up next weekend, the servo's finally shipped today.

sdstick06 03-01-2008 09:50 AM

RE: Extreme Flight Extra 58"
 
Hi Michaelh.... thanks for your reply!

What are your thoughts on the Extra so far?

Michaelh 03-01-2008 02:26 PM

RE: Extreme Flight Extra 58"
 
Its nice, I really like it. The engine mounts could have had a better fit ,but work. Incidences are good, had to tweek a wing a little,like maybe 3/4 of a degree twisted.I dont think many people would even bother with that though.
So far the build has been straight foward. Have not had any problems or issues with it.


The 82a is a nice running little engine also. Going to try a 15x6 with 30% but the 15% on a 14x6 does good.

sdstick06 03-01-2008 07:01 PM

RE: Extreme Flight Extra 58"
 
Thanks for the report Michaelh!

Michaelh 03-02-2008 12:52 PM

RE: Extreme Flight Extra 58"
 
Also know that CG may be an issue on these glow conversions. Running the dual elevators may be necessary.

Ill know more for sure later this week.


Anybody else? Reports have said that the plane has dwindled the supply of 5245's so there has got to be more people with this plane.

badfish 03-03-2008 08:47 PM

RE: Extreme Flight Extra 58"
 
I've had mine for a while now.
saito .72
4 5245's
1 225 mg (throttle)

I used the elevator joiner so I could use the second elevator cut-out for a push-pull rudder.
kind of a waste putting 2 $50 servos on the elevator. 5245 on the rudder is plenty also. KE loops no problem.
also frees up the rudder servo pull-pull area for room to mount the battery and rx.
be careful of the canopy/ hatch paint. it chips easily. I took some hinge tape and ran it along the edge of the hatch that goes beneath the cowl.
don't over tighten the spinner screws. It will split the plastic.
when mounting the wheel pants. a bit of 2 sided sand paper in between the landing gear and wheel pant will hold it on a little better. I fly off rough grass and had 1 fly off till I used some sand paper and really tightened them down well.
balanced fine no added weight. just moved my rx battery.
I usually use a apc 13 x 6 propeller on my 72 but came across master airscrew 13x6 S2 series glass filled nylon propeller on tower. I have a new favorate prop for this engine. spins just over 11 grand on the ground and really jumps out of a hover.

steve.

sdstick06 03-03-2008 09:05 PM

RE: Extreme Flight Extra 58"
 
Thanks for the report badfish... it is really appreciated

Can you tell us a bit about the flight characteristics?

Also was the conversion to glow any problem?

SDS

badfish 03-04-2008 01:25 PM

RE: Extreme Flight Extra 58"
 
plane flys great. almost no coupling in KE. cg will influence this tho. first time I attempted a KE loop I was shocked it didn't flop out of it at the top of the loop. sat right in it like a profile. flat spins great. getting a little rock in upright harriers but I need to add some weight on the left side of my plane. I'm flying with some right ail. trim. landings are a breeze. it will go pretty slow before it looses lift. covering is awesome. I left my pilot and floor out so I could see my fuel tank. which I mounted only half-way back to the wing tube. thats a bit far for most glow engines liking. when I get a chance I'll post a few pics.

the conversion was pretty simple. EF gives you ply already cut to correct dimensions to glue around the firewall. I started gluing them and then realized the firewall has right thrust built in. so certain pieces have exact locations. the ply strengthens the whole front end.

steve

sdstick06 03-04-2008 01:44 PM

RE: Extreme Flight Extra 58"
 
Thanks so much for that info badfish.... it is really appreciated!

sdstick06 03-04-2008 02:42 PM

RE: Extreme Flight Extra 58"
 
Can you use standard size servos? DS821's???

Michaelh 03-04-2008 04:14 PM

RE: Extreme Flight Extra 58"
 
Only on the rudder. Got my 5245's in last night and the CG is working out good so no problems there. Wx dependent Ill have her up this weekend on 30% with a Zinger 15x6 , Im hoping for around 9200 rpm with it but well see. That would be kinda insane :)

sdstick06 03-04-2008 04:28 PM

RE: Extreme Flight Extra 58"
 
Does it look like you might be able to open up the servo holes a little and use standard size servos? Wouldn't take much.... standards are only slightly larger then mini's


mini's 0.7" x 1.3" x 1.2"

Standard 0.75" x 1.49" x 1.52"

Open the width 0.05" and the length 0.19" and ya got it.... pretty sure you would be ok on the depth.... would just be a 0.32 increase in depth

What do you think??

Thanks,
SDS

Michaelh 03-05-2008 04:32 PM

RE: Extreme Flight Extra 58"
 
Nah theres no way on the tail. there is just enough wood to hold the mini's in. the wing has a recessed desighn in it . I may or may not be wrong but wing seems a bit skinny for them also.

Anything is possible I know. But there will be major mods to be done to fit them in.

Ill see what I can show you on a pic ?

sdstick06 03-05-2008 04:50 PM

RE: Extreme Flight Extra 58"
 
Thanks Michaelh.... pics not neccesary.... I appreciate it the info!!

SDS

sdstick06 03-07-2008 11:04 AM

RE: Extreme Flight Extra 58"
 
I think I like how badfish did his servos...2 in the rear and no pull pull. That's how my Funtana X 50 is set up and it works great

How well does this the Extra do precision? Is it smooth flying.... does it groove?

I am real close to being able to order mine.... scraping up cash... almost there!!! (very jazzed!)

SDS

badfish 03-07-2008 03:21 PM

RE: Extreme Flight Extra 58"
 
1 Attachment(s)
Plane is very smooth in precision flying. I believe I read the fuselage is stretched to help in that area. there is a very good video on FG's site.


Michaelh 03-07-2008 04:16 PM

RE: Extreme Flight Extra 58"
 
Hey SDS thats what its all about, doing your own thing. There is a video of it with the electric version here http://www.youtube.com/watch?v=iMrl6OYRgx0 other videos also.
You may have seen but if not enjoy!

Weather is poop here so maybe Sunday will bring good flying.

BTW are you on RCG as sdstick?

Mike

sdstick06 03-07-2008 05:54 PM

RE: Extreme Flight Extra 58"
 
Thanks guys.... yep sdstick on RCG

What a great video!!!

how much better are the 5245mg's then the 225mg's???? (on a budget here)

SDS

Michaelh 03-07-2008 06:03 PM

RE: Extreme Flight Extra 58"
 
Really were just fooling ourselves with the digitals .The 225's will work great.

sdstick06 03-07-2008 06:11 PM

RE: Extreme Flight Extra 58"
 
Oh man... that's great news on the servos Michaelh... thanks

sdstick06 03-07-2008 07:36 PM

RE: Extreme Flight Extra 58"
 
How does it handle in the wind?

Michaelh 03-07-2008 07:36 PM

RE: Extreme Flight Extra 58"
 
Yep, Check out this video. http://www.flyinggiants.com/gallery/...hp?photo=38642

Insert FG's URL where the block is

sdstick06 03-08-2008 01:49 PM

RE: Extreme Flight Extra 58"
 
How do you think this plane compares to the Fliton Extra 330s freestyle? (might have found an op to buy a Fliton cheap)

Michaelh 03-08-2008 03:11 PM

RE: Extreme Flight Extra 58"
 
I have not flow the 58" yet so I can not compare the two. Although the 330 is a nice flying plane for sure.

Mike


All times are GMT -8. The time now is 05:54 AM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.