Need Help with ELEV settings??????
 

Not sure if this is the right place to post this but here goes!

I have an Extreme Flight Yak-54 with 88" wingspan, got it all set up and noticed I couldn't get the left elevator to work, I went in my transmitter to set it up, but still nothing. I know there is someone out there that has ran into this problem before. Any help will be greatly appreciated.

My Tx is a spektrum DX7 and RX is a spektrum AR-7000, everything is plugged were it belongs. Running 6 servos and one kill that is pluged into the gear slot.

ALE=ALE+aux 1
Rudder=Rudder
Thr=Thr
Bat=Bat
Ele=Ele+aux2
Kill=Gear

RE: Need Help with ELEV settings??????
 

Start at the servo monitor screen, see if the channel is doing what it should.

If both bars are moving then you have a servo connection problem or a dead servo. If not then your mixes aren't set up right.

RE: Need Help with ELEV settings??????
 

maybe you need to activate the dual ELEV or it might be different with the dx7...for example on my tx i have to use aux 3 and select dual elev

RE: Need Help with ELEV settings??????
 

figured it out last night, thanks for all ya'll help!