RCU Forums - View Single Post - Adding an LED to Rx channel?
Thread: Adding an LED to Rx channel?
View Single Post
Old 12-13-2002 | 08:01 PM
  #1  
wsmalley
Senior Member
My Feedback: (6)
 
Joined: Feb 2002
Posts: 1,080
Likes: 0
Received 1 Like on 1 Post
From: Monterey, TN
Default Adding an LED to Rx channel?
Several years ago there was an article in RCM showing how to plug an LED into your Rx. I don't remember if there was a resistor, or any other device, in the 'circuit' What about a blinking LED, would that make any difference in the circuit? Would either affect reception in any way? Any comments?
wsmalley is offline  
Reply Like