RCU Forums - View Single Post - Reflection 3D building and flying!!
Thread: Reflection 3D building and flying!!
View Single Post
Old 05-28-2006 | 06:31 PM
  #21  
SuperKaos's Avatar
SuperKaos
Senior Member
My Feedback: (2)
 
Joined: Jul 2002
Posts: 192
Likes: 0
Received 0 Likes on 0 Posts
From: Granite Falls, NC
Default RE: Reflection 3D building and flying!!
ORIGINAL: SS2P

Hi,

putting the pushrod to clevis is total BS. I'm trying to do it for the whole day+ my fingers bleed so badly. [:@][:@][:@]
I started at 7:30 am and now it's 4:00 pm and basically in the same step..putting this plane together is totally sad. I hope flying is worth it.


Paul
It takes a bit to figure out the QUIRKS of the kit. I use an xacto to shave the push rods down to size. I shave it while holding it 90 degrees to the push rods.
SuperKaos is offline  
Reply Like