RCU Forums - View Single Post - Evolution .46 troubles
Thread: Evolution .46 troubles
View Single Post
Old 06-06-2006 | 09:19 PM
  #4  
MinnFlyer's Avatar
MinnFlyer
Senior Member
My Feedback: (4)
 
Joined: Apr 2002
Posts: 28,519
Likes: 0
Received 9 Likes on 9 Posts
From: Willmar, MN
Default RE: Evolution .46 troubles
This info comes straight from the MFGR:

Open the carb 1 millimeter

Close the low-end needle

Open the low-end needle 1 1/5 (One and one fifth) turns.

That is where it is SUPPOSED to be set at the factory, but a few slip by that are not set correctly
MinnFlyer is offline  
Reply Like