10X bugging! ? need help
Hi
I would be very greatful if someone could help me with this problem on my PCM 10X Air:
When moving the stick to give elevator the control surface moves up... more and more, when the stick reaches approx 80% the servo suddenly goes back to 0% throw! this happens when useing big thows ~120-135% or V-tail where the servo throws are big too.
think it is a Tx problem, because when looking at the display in the menu for servo movment the "viritual"servo also neutralizes.
some times I can get rid of the problem by setting DR to 75%, but suddenly the same glitch appears again! very scary!
noticed this on two diffrent models now, both useing Schulze 435 Rx.
thanks