ORIGINAL: jinzo
The price range sounds just fine. I was personally worried that it might end up being twice that price.
Speaking of fiberglass molds, I should look into how they are made. I've personally never done a mold, but I have done vacuum bagging, so I would imagine a similar amount of work is done and the skill levels are likely along the same line.
Keep up the awesome work! [sm=thumbs_up.gif]
Since you are showing an interest in mold making; here is, by far, the best thread on the entire mold making process that I have ever seen on RCU. I've referred to it countless times and learn something new every time I read it.
Enjoy: [link=http://www.rcuniverse.com/forum/m_2927309/mpage_1/key_/tm.htm]A-7 Build[/link]
Also is a site that has plans and instructions to build a $30 hot wire machine: [link=http://www.instructables.com/id/EK8Q92824BEP286S6S/?ALLSTEPS]Cheap Hot Wire Machine[/link]
Sometimes trolling pays off
,
Mods